Forever 30W TC Mod
Compatible with ordinary atomizer of 0.1ohm - 3.0ohm
Recognizing automatically whether the atomizer is Ni-200 atomizer or ordinary atomizer when it is in temperature control mode
When battery is low, the mod will adjust the output power automatically
Low-voltage protection for below 3.2V voltage
Temperature protection and over-smoking protection
With built-in lithium 18650 battery
Micro charging seat voltage: DC 5V
Maximum charging current 800mA
Charging time 3 - 5 hours
Maximum output current: 17.5A
Output power: 1.0W - 30W
Nickle 200 atomizer working resistance: 0.1 - 1.0ohmHarvest Tank
5.0ml juice capacity
Support top filling
Huge cooling vapor
304 stainless steel tank with ovenproof pyrex glass
2 bottom airflow holes
3 drip tip airflow holes
Pre-installed a 0.2 ohm nickel coil
Includes a 0.5 ohm normal coil
Coils are compatible with Kanger Sub TankDetailed Parameters
Forever mod: 76 x 35.7 x 23.4mm
Harvest Tank: 22 x 22 x 73.8mmOperation Guide:
1. On / Off Battery Switch
By pressing the fire button, the screen will display “ DOVPO” logo. It leads you to the main interface.
2. Sleep Mode On / Off
The screen goes dim after 60 seconds of on operating. Sleep Mode will be turned on 5 minutes of operating. Wake up this device by pressing the fire button when in Sleep Mode.
3. Wattage Adjustment
You can adjust the desired wattage by pressing “ + ” or “ - ” button from 1 - 30W in 0.1W increments. Holding either button will cause the wattage to increase / decrease quickly.
4.Replace an atomizer
When changing the atomizer the screen will ask “ New coil on same down” Press the “ + ” button to confirm that is a new atomizer. Pressing the “ - ” button will tell the device it is the same atomizer and the resistance will be the same as before.
5. TC / Wattage Mode Switch
When in Lock Mode, press and hold “ + ” and “ - ” button until “ HOLD TO CHANGE TEMPERATURE ” appears om the screen, then it leads you to temperature settings. Long press “ - ” button until Celsius value appears to switch to Celsius. And again will switch to Fahrenheit. To switch to Wattage Mode, press and hold “ + ” button until “ OFF ”appears on the screen, the press the fire button to confirm.